*Please Note: This item is only available to be shipped Australia-wide*
The 1K FillClean 298 ml cans facilitate filling mixed water-borne basecoats from the manufacturers listed below. There is a specific formula for each paint manufacturer, which ensures an optimum spray application with the respective SprayMax 1K FillClean can.
Technical Information
Application:
Part painting and spot repair
Pre-treatment:
Pre-treat substrates as usual up to the basecoat and clean with SprayMax Silicone Remover.
Spray application:
2 spray applications = approx. 20μm
Interim flash off: approx. 5 min
Important: flash off until matt
Drying times:
Recoatable after approx. 15 min
Additional processing:
Recoatable with SprayMax 2K Clear coat after flashing off matt
Yield:
Approx. 0.5m² - 1m² / spray can depending on the application thickness and substrate
Notes:
To be used by specialists only
Wear personal protection gear (respirator type: A2/P2 safety gloves, e.g. Latex or nitrile)
After finishing the painting process, turn the can over and spray the valve empty.
Dispose of the completely empty spray cans as recyclable material
Filling volume: 100g, undiluted
After filling, shake can approx. 2 min.
Important: Before using, shake can for approx. 2 minutes
Shake again before every spraying application
SprayMax Fill In is a semi-finished product. The final product by through filling. The filler is liable for the final product
Add A Review
Your email address will not be published. Required fields are marked
Your Rating