$ 39.00
$ 29.00
Fits: Creality CR-10S Pro and Anycubic Kobra Plus
(Please see full printer list below on the 'Fits & Contents' tab)
The Wham Bam Flexi Plate is made from high-quality flexible spring steel designed to be bent thousands of times without kinking. The spring alloy contains a high level of chromium to ensure no rust or oxidation for its lifetime.
Build surface sold separately.
Printer Fits:
• Anycubic Kobra Plus
• Comgrow T300
• Creality CR-10S Pro
• Creality CR-10S Pro V2
• Creality CR-10S Pro V3
• Creality CR-X
• Creality Ender 3 Max
• Ender 3 Max Neo
• Formbot Troodon 300
• goofoo Nova
• Sovol SV06 Plus*
• Sovol SV07 Plus*
May fit:
• Anycubic Mega X
• Creality CR10 Smart
• Kywoo Tycoon Max
• Sovol SV04
*for the SV06 Plus and SV07 Plus, you will either have to remove the two alignment screws at the rear of the build plate or mount the Flexi Plate 5 mm over the front of the bed.
Do you have a printer similar to what's listed under Printer Fits or May Fit?
Note: You should already have a magnet or clips installed on your printer, as this is needed to use a Flexi Plate.
Optional install of the build surface:
If your machine has automatic bed leveling, run the leveling process and set your gap such that the first layer is well squished. For more details on achieving the right first layer squish, refer to this bed leveling guide.
If your printer uses manual leveling, follow the same guide for instructions on the leveling process.
Full support info can be found on our support page.
Add A Review
Your email address will not be published. Required fields are marked
Your Rating