Original Creality Replacement Hotend Assembly For Ender 3 S1 Pro for Ender 3 S1 / Ender 3 S1 Pro, CR10 Smart Pro
Hot tightened at factory, but we do recommenced you re-tighten nozzle again, you need to re-tightened at +10-20c your regular printing temperature (example 280c for all metal version) or at max temperature of support hotends when you change the nozzle.
Documentation: https://support.dremc.com.au/en/support/solutions/articles/51000318231-how-to-hot-tighten-nozzle-change-a-nozzle
How Replace Hotend: https://support.dremc.com.au/en/support/solutions/articles/51000365933-how-to-replace-ender-3-s1-series-sprite-extruder-hotend
Standard Kit: Stainless Steel Heat Break (PTFE LINED Heat Break)
- Brass Nozzle 0.4mm
- 24V 40W Heater
- Stainless Steel + PTFE Lined Heat Break
All Metal Kit: Titanium Alloy Heat Break (All Metal Heat Break)
- Brass Nozzle 0.4mm
- 24V 50W Heater
-
Titanium Alloy Heat Break
High Temperature Pro Kit: Chrome Copper + Titanium Alloy (All Metal Heat Break)
- Copper Plated Nozzle 0.4mm
- 24V 50W Heater
- Copper + Titanium Alloy Heat Break
Looking for better hotend and better part cooling? Check out TL CHCB OT Hotend: https://store.dremc.com.au/products/trianglelab-chcb-ot-hotend-for-sprite-extruder-k1-k1-max?variant=43166347231401
All kits include retaining bolts, sock and respective thermistors.
Support Printers/Upgrades Kits (Ender 3 Series**)
**Note: Some reports of Creality sending different PCB on some sprite extruder or ender 3 S1 printers, double check your PCB you're replacing, if you has larger thermistor header, you may need CR-M4 version hotend or need new PCB. [https://store.dremc.com.au/products/sprite-extruder-breakout-board]
Note: For printing extensive abrasive filament printing such as Carbon Fibre/Glass filled filament, please use the All Metal Kit (All Metal) with hardened steel nozzle- 4001030113 instead of the bi-metal hotend (Pro Kit). During our testing, we found the bi metal hotend does not last long before abrasive wear at the bi metal heat break.
Note: Please check compatible table in second image, please also note this is not compatible with Sermoon Printer as the Heater/thermistor due to different cable length and connector but rest of hotend is compatible, so you are required to remove existing heater/thermistor or extend wiring before install. If you need Sermoon variant hotend: https://store.dremc.com.au/products/hotend-kit-for-sermoon-v1-pro-sprite-extruder
Note: These are direct hot-swap replacement, thermistor is not replaceable, if you need replaceable heater blocks, please see below options: Aluminum Heater Block / Copper Heater Block [Require self assembly and does not include retaining blocks] similar you can source any MK8 nozzles or CR-6SE/sprite Specific for stock silicon sock. Heat Break options available in copper+titanium alloy.
Add A Review
Your email address will not be published. Required fields are marked
Your Rating