Note: this kit is suitable for Kywoo Tycoon series 3D printers. The motor is included.
Attention: If you want to install and use the dual gear extruder, you have to reflash the firmware to V2.1.3 and set the E steps from 93 to 127.4 in your settings. Pls also remember to follow the datum line when you install it. Otherwise the extruder may couldn't work normally. (PS 1: The firmware of IDEX is V2.2, you can directly set Esteps to 127.4 and don't need to reflash the firmware. PS 2: Pls note that Mini couldn't use the dual gear extruder.) If you need the firmware V2.1.3, pls contact with [email protected] and tell us which printer you have(Tycoon, Max or Slim), we will send the firmware to you asap. No worry.
Here is the link of how to install dual gear extruder: https://www.youtube.com/watch?v=5cC1tVqL8kY
Here is the link of how to change the Esteps: https://www.facebook.com/groups/kywoo3dofficial/permalink/935789320931165
Add A Review
Your email address will not be published. Required fields are marked
Your Rating