- Simple, Secure Mounting: Attaches to Slatwall via hook on the back of the mount and included printed T-nut and screw on bottom of mount. Insert printed nut into Slatwall slot underneath where you will place the hooked part of the mount. Rotate the nut 90 degrees to lock it into place. Then hook the mount into place and insert the screw through the bottom hole and into the printed nut. Tighten the screw to secure the mount to the slatwall.
- Multiple Versions: Choose if you want the muzzle of the firearm facing right or left, and select between many different colors.
- Wide Slatwall Compatibility: Variations available for Hold Up Displays, Savior Equipment, StoreWall, Patrick Industries / Decorative Dynamics "Slotwall", Menards Slatwall (specify with or without metal track insert), and generic Slatwall (blue, green, and red dimensions in the images below).
If you don't know your Slatwall type, order this bundle to test: https://hammy3dprints.com/products/slatwall-test-fit-bundle-slatwall-magazine-holder-storage-rack
- Low Profile, Sleek Design: Proudly display your collection and make your firearm easy to access. The mount sits flush with the wall and holds the firearm for easy retrieval.
- Perfect Fit: Works with rifles using MDT short action (6.5/308/etc.) magazines. This mount latches onto the mag catch/release which must be activated to remove the firearm from the mount. The Inline Vertical version holds the firearm perpendicular to the mounting surface to allow for high-density storage.
- Original, Innovative Design: 2000+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.
NOTE: The Skinny - Metal version is too thin to use the nut and will instead be friction fit on the bottom.
Disclaimer: This product is not manufactured, authorized, endorsed, or warranted by Hold Up Displays or Savior Equipment or Menards® or StoreWALL or Bergara. It is solely designed and produced by Hammy3DPrints.
MATERIAL: 3D printed using PLA+ filament. Note that this filament is not a high-temp filament rated for use inside vehicles left in direct sunlight during summer. If you require a higher-temp filament please contact me.
INSTALLATION: Attaches to Slatwall via hook on the back of the mount and included printed T-nut and screw on bottom of mount.
WARRANTY: If this item breaks I will make any design adjustments, if needed, and send a replacement for free.
Made in USA.
Please note that the products may have slight imperfections as 3D Printing is rarely perfect. The exact product you receive may also slightly vary from the product photos as I iterate and improve upon designs based on user feedback.
Add A Review
Your email address will not be published. Required fields are marked
Your Rating