$ 159.99
$ 159.99
How to Video:
Internal ELRS Rx Firmware flashing:
Review Video:
Flight Controller： BeeBrain BLv4 ELRS
MCU: STM32F411
VTX: Switchable output power from 5mw- 25mw(for Racing) - SmartMAX(SmartMax up to 400mw) with BeeTX 5.8Ghz Antenna
ESC: 12A BLHeliS Pre-Flash with Bluejay 0.16 target: S-H-40 48kHz
ESC Connector: JST-1.0 3Pin
OSD: NBD7456 Graphical OSD compatible with Betaflight OSD
Receiver: ELRS2.4 Diversity receiver(ESP32 compatible with wifi&bluetooth firmware update) 2.4G T-Antenna(Top) & 2.4G antenna with MHF3 Connector (bottom)
Flight Controller Weight: 6.5g(Include antennas and battery connector)
Flight Controller Size: Outer dimensions: 29x29x7.6mm
Flight Controller Holes: 25.5x25.5mm
Battery input: 1-2S (Preset only support 1S, 2S will need throttle cap at less 50%)
Uart2: Tx&Rx for ExpressLRS2.4G Receiver
Uart1: Tx&Rx free
Power Connector: NBD-PH2.0 connector
Motors: Flow 0802 27000kv
Frame: Cockroach65 Brushless Frame Clear Purple
Camera Mount: Goober Canopy Clear Purple
Propeller: Azi Tri-blade 31mm 1.0 Clear Purple
Batteries not included.
Recommend Battery:
Nitro Nectar Gold 300 mAh 1S PH2.0
Nitro Nectar Gold 250 mAh 1S PH2.0
Firmware:
1. ELRS Receiver firmware can be found here. Vendor choose NewBeeDrone
2. BeeBrain blv4 ELRS Betaflight 4.4 firmware
All new firmware can be found on our Github Page
Note: Binding process. power up the drone 3 times, on the third time you plug in power, the ELRS Receiver will get into binding mode. We are still trying to work on the ELRS firmware and make it able to just click the boot button to get into bind mode. Will get this update in the near future.
Check out the video below CiottiFPV show you how to get into bind mode. - Thanks bro for showing this. lol
Add A Review
Your email address will not be published. Required fields are marked
Your Rating