- Pre-press your substrate/product with the recommended silicone pad and settings from the table below.
- Place your design on your substrate/product (printed-side facing down) and if necessary, fix it with heat-resistant tape.
- Press your transfer with the parameters indicated below and cover it with the recommended silicone pad in the table below.
- Peel the transfer paper by using the recommended settings from the table below. ATTENTION: At this point, the substrate is very hot. Take precautions while handling it.
- If indicated in the table below, re-press your substrate/product with the same temperature as in step 3 for about 2-5 sec.
