RECO LEG COMPRESSION USER GUIDE AND DISCLAIMERS

BEFORE USING

Please check the battery power by pressing power button ON.

If the pump does not start, it is out of battery and needs to be charged using the charger. The indicator light on the adapter will light up in a red color.

The light will become green while charging and battery indicator light will show

full when fully charged.

1 • Securely connect air hose to cuffs

2 • Securely connect the main plug of air hose to pump

3 - Put on the cuffs on comfortably

4 • Press the power button to put the pump on stand by mode.

Note: the power button is at the front side of the pump. Press O to turn off the pump.

5 • Set the desired time by choosing button

(10 to 90 mins)

Note: default is 30 mins. To reduce/increase the time by 5 minuts intervals, hold your finger on the button for a short period. When the tine runs out, the pump turn off automatically.

6 • Set the desired pressure level by pushing button

80 to 260 mmHg)

Note: Default is 80 mmHg. To reduce/increase the pressure hold your finger on the button for a short period. The pump stops work below 80 mmHg.

7 • Select the desired massage mode by pushing any of the buttons.

Note: Default mode is 1. It is only possible to switch to the desired mode when the machine is paused.

8 - Pressing position button one time, chamber will move a grid, then the moved chamber from lighting to flashing, pressing confirm button the light off, it means the number of closed chamber will not be inflated when machine started working, can close more chambers.

9 • Press the on/pause button. •1

Note: after all settings are completed, press the start key to begin the session.

AFTER USE

- Disconnect the hose from the machine by taking the cable out. 

- The cuffs and hose should always be connected and used as a whole. Do not disconnect the hose and cuffs frequently as this may cause damage to the pins or hose. 

Note: when traveling with the product, the hose and cuffs can be disconnected to save space. 

NOTICE: NO PULLING THE HOSE

Disconnect the hose from cuff by holding pins to pull up. 

REMINDER

- After using, when storing the pump, be careful to pull the hose plug off from the pump by pressing clips at the double sides of the hose plug, to avoid breaking the plug. 

-Avoid removing the hoses on the boots all the time. When you are traveling with your boots, you could disassemble to optimize the space in the bag, but it is not necessary. 

-Avoid tearing the hoses when you disassemble by holding the pins up. 

CLEANING AND MAINTENENCE

• Turn off pump before cleaning
• Don't wash the machine and cuffs
• Wipe with a dry or damp cloth
• Keep in a clean and dry place
• Protect the equipment from direct sunlight or heat, such as gas stove.

WARNINGS

• Do not unzip the cuffs when the unit is on
• Always turn the power off before unzipping the cuff
• Do not get the pump wet
• Make sure the pump is on a flat surface.
• When using the machine, do not move with the cuffs. 
• The equipment cannot be repaired and maintained during use
• Please consult your physician before use. This product is not intended to diagnose, treat, or cure any diseases. 
• Contraindications include (but not limited to): acute inflammatory skin diseases, arrhythmia, erysipelas, deep thrombo phlebitis, pulmonary edema, acute venous thrombosis, unstable hypertension, patients with a peacemaker.